Baseline-systems BL-FLOWSTN-P FlowStation Module Uživatelský manuál stáhnout pdf

BL-FLOWSTN-P FlowStation Module

Installation Guide

1-866-294-5847 Rev 9.5.2014 www.baselinesystems.com

Introduction

Baseline’s FlowStation is available as an add-on

module that is installed inside a pedestal enclosure

with a BaseStation 3200 irrigation controller.

The FlowStation module comes with a 3-port

ruggedized Ethernet switch (BL-ETH-SW).

When the FlowStation is ordered with a BaseStation

3200 irrigation controller in a pedestal, the Flowstation

is installed in the pedestal at the factory.

The following instructions describe the steps for

installing the add-on module into a pedestal that is

already in service.

Required Tools

You will need a Phillips head screwdriver.

Shutting Down Power to the Pedestal

1. On the BaseStation 3200, turn the dial to the Off

position.

2. Open the lower door on the pedestal and locate the

on/off key on the power box.

3. Remove the screw that fastens the key to the box.

IMPORTANT! Put the screw in a safe place because you

will need to replace it later.

4. Insert the key into the on/off switch and press it down

to turn the power off.

5. Remove the key and reattach it with the screw to

prevent it from being misplaced.

1 2 3 4

BL-FLOWSTN-P FlowStation Module Installation Guide 1-866-294-5847 Rev 9.5.2014 www.baselinesystems.

BL-FLOWSTN-P FlowStation Module Installation Guide 1-866-294-5847 Rev 9.5.2014 www.baselinesystems.

BL-FLOWSTN-P FlowStation Module Installation Guide 1-866-294-5847 Rev 9.5.2014 ww.baselinesystems.

BL-FLOWSTN-P FlowStation Module Installation Guide 1-866-294-5847 Rev 9.5.2014 ww.baselinesystems.

Žádné komentáře

Baseline-systems BL-FLOWSTN-P FlowStation Module Uživatelský manuál